2/28/2024 0 Comments Free for apple instal Coherence X![]() Rack/Slot/Instance/Port of the optics controller.ĭisplays performance monitoring parameters for the controller.ĭisplays the current performance monitoring data in 30 second, 15 minute, and 24 hour intervals.ĭisplays the historical performance monitoring data in 30 second, 15 minute, and 24 hour intervals.ĭisplays the PM data for optics controller.ĭisplays the performance monitoring data for the applicable lanes in the optical module. The show controllers optics command in XR EXEC mode. To display status and configuration information about the interfaces configured as optics controller on a specific node, use Last clearing of "show controllers OTU" counters never show controllers optics UC-WORDS : 0 Threshold : 5 TCA(enable) : YES Router# show controllers coherentDSP 0/0/0/13 pm current 30-sec fec The following is a sample to view the current performance monitoring parameters of the coherent DSP controller in 30 second Router# show controllers coherentDSP 0/0/0/13įECMISMATCH = 0 FEC-UNC = 0 FLEXO_GIDM = 0 ![]() Once you see your sensor ID number displayed and verify that it matches the number on. Open the Inner Balance app and press the Start arrow to make the app start scanning for the sensor. Default values are set to optimize the power consumption by the QDD-400G-ZR-S and QDD-400G-ZRP-S modules. Clip the sensor to your earlobe and press the soft button on the sensor pod to activate a blue flashing light. These configurations must be removed before the no hw-module configuration. The configurations for chromatic dispersion, cd-low-threshold, and cd-high-threshold) must be performed only after the hw-module configuration. Optics controller configuration Usage Guidelines The host auto-squelch disable keyword was introduced. QDD-400G-ZR-S and QDD-400G-ZRP-S Default Traffic Configuration Values The range is -190 to 50 dBm (in the units of 0.1 dBm).Įnables or disables performance monitoring.Ĭommand Default Table 1. (Only for trunk optics controllers) Configures the transmit power. Sopmd (second order polarization mode dispersion) Low-freq-off (low signal frequency offset) The PM parameters that can be configured are: The threshold keyword configures threshold values for the PM parameters. The report keyword configures threshold crossing alerts (TCA) reporting status for the PM parameters. To configure the coherent DSP controller, use the controller coherentDSP command in the Coherent DSP controller configuration mode.Ĭontroller coherentDSP R/S/I/P [ description description | perf-mon pm-parameter valueĬonfigures performance monitoring parameters for 30-second, 15-minute, and 24-hour intervals.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |